User's Manual

32
Using the Detergent Again
再次使用洗衣液
How to use the "PRESET" button (Switched options)
預校按鈕的使用方法（切換內容）
■ The preset function allows the finishing time to be set to 6 hours or 9 hours later. This feature comes in handy when you
wish to do the washing while you are out or when you wish to do the washing at night and hang out in the morning.
可將洗衣完成時間設定在6小時後或9小時後，在外出時進行洗衣，或在夜間洗衣早晨晾曬，利用本功能是相當便利的。
■ Press the "PRESET" button to set the washing content.
按下預校按鈕，設定洗衣內容。
6 hours later(Light)
6小時後(點亮)
9 hours later(Light)
9小時後(點亮)
No setup(Darken)
無設定(熄滅)
PRESET PRESET
PRESET
In the following cases
在以下情況下
■ Fix the preset duration: press the "PRESET" button .
(With the button pressing and holding, the preset duration
will be displayed)
確認預校內容：按下 按鈕。
(持續按下期間，顯示預校內容)
■ Cancel the preset duration: switch off the power
"ON/OFF" button
.
取消預校內容：切斷電源開關
。
■ Change the preset duration: switch off the power
"ON/OFF" button
, and reset.
更改預校內容：切斷電源開關 後，重新設定。
Attention 注意
• In predefined operation, do not mix the clothes liable to
discoloration.
預校運轉時，請勿將容易脫色的衣物混在一起洗滌。
•
With the power unplugged or cut, the preset process will be canceled.
拔掉電源插頭或停電時，預校程序將被取消。
• The washing time varies with the change of the load and
texture of the washings and the volume of the charged water.
洗衣時間隨洗衣量和質地及供水量的變化而改變。
• To prevent the laundry from corrugating, take it out for drying
as early as possible after the end of washing.
為防止衣物起皺，洗衣結束後應盡早取出晾乾。
Use the detergent again
再次使用洗衣液
"Washing" only for the 1st
collective of laundries.
對第一批衣物進行“單洗”。
1
Put in the 2nd collective of laundries, and select
the favorite washing mode.
放入第二批衣物，選擇喜歡的洗衣方式進行洗衣。
• Set the proper water level for the laundries.
設定適合衣物的水位。
2
Rinse and spin the 1st collective of washed
laundries.
對第一批已經洗過的衣物進行沖洗和脫水。
• Set the proper water level for the laundries.
設定適合衣物的水位。
3
Laundry with
slight dirt
不太髒的衣物
Washing only
單洗
Washing → Rinsing
→ Spinning
洗衣 → 沖洗 → 脫水
Rinsing → Spinning
沖洗 → 脫水
Using the PRESET for Washing
預校時間洗衣（續）
※ Predefined operation can’t be set in "WOOL", "BLANKET", "CLEAN", "AIR JET" Processes.
『毛絨』、『被毯』、『清潔』、『風乾』程序不能設定預校運轉。