Operation Manual

English
6
MODEL
WP12DM: with charger and case
SPECIFICATIONS
POWER TOOL
Model WP12DM
No-load speed 0 – 2600 min
–1
(/min)
Capacity ø3.5 – ø9.5 (Wood screw)
Rechargeable battery EB1220BL: Ni-Cd battery, 12 V (2.0 Ah 10 cells)
Weight 1.9 kg
STANDARD ACCESSORIES
1. Charger (UC14YFA) ................................................... 1
2. Plastic case ................................................................ 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES
(Sold separately)
1. Plus driver bit
2. Wood working drill: Code No. 959183
Optional accessories are subject to change without notice.
CHARGER
Model UC14YFA
Charging time EB1220BL: Approx. 50 min. (at 20°C)
Charging voltage 7.2 – 14.4 V
Weight 0.6 kg
Bit No. Code No.
No. 2 992671
No. 3 992672
APPLICATION
Design for driving wood screw
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery. (Figs. 1 and 2)
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the oil pulse driver, charge the battery as
follows.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s
pilot lamp will blink in red. (At 1-second intervals.)
2. Insert the battery into the charger.
Insert the battery firmly, in the direction shown in
Fig. 3, until it contacts the bottom of the charger
compartment.
CAUTION:
䡬 If the battery is inserted in the reverse direction, not
only recharging will become impossible, but it may
also cause problems in the charger such as deformed
recharging terminal.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light up
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)