User's Instructions

– –

the right side of the transmitter, carefully turning it as you would turn the page of a book. Now

you’ll see the view shown.

Using a small cross-point screwdriver, rotate the adjusting screw for each stick for the

desired spring tension. The tension increases when the adjusting screw is turned clockwise, and

decreases for counterclockwise motion. When you are satisfied with the spring tensions, you

may close the transmitter. Very carefully reinstall the rear cover. When the cover is properly in

place, tighten the six screws.

Ratchet change

Some pilots prefer a “softer” or “smoother” ratchet action on the throttle stick. Included

as an accessory in your Eclipse 7 system is an alternate ratchet that provides a smoother

ratcheting action.

After removing the back of the transmitter case as directed above in the “stick lever

tension adjustment” section, remove the ratchet retaining screw, remove the old ratchet and

replace with the new one.

Changing the Eclipse 7 transmitter’s mode

If you wish to change the mode of the transmitter, say from Mode 2 to Mode 1, return the

radio to Hitec for conversion. If you don’t know what this means, you don’t need to worry about

it!

Factory Service Repair Information

Please read the warranty card supplied with your system, and return it so your system will

be under warranty.

Before you decide to have your system repaired, if there is no apparent physical damage,

read this instruction manual again and check to be sure that you are operating the system as it is

supposed to be operated. If you are still having trouble, pack up your system in its original

shipping materials and send it to the factory or the nearest authorized Hitec R/C Service Center.

Be sure to include a note in your package that describes the trouble in as much detail as

possible, including:

• Symptoms of the problem in as much detail as you can provide, including any

unusual mounting conditions or equipment orientation

• A list of items you are sending, and what you want to be repaired.

• Your name, address, and telephone number.