User's Instructions

– 21 –
stored within by the memory number.
9:56 136
4213567
MODEL
Pressing the
start/stop
button gives the Timer display, with a
stopwatch display on the left, and operating time on the right.
This also starts the timer, so hit the
start/stop
key again to stop
it. Hitting the Cursor Left (Off) button resets the timer and
return to display mode.
10.1V 10
421 3 567
MODEL
LOCK
LOCK indicator
Pressing the Lock button locks the throttle servo and holds it
where you last commanded it. This may be used as a safety
feature when you are carrying the model and transmitter to
ensure you don’t accidentally give throttle. It is shown by the
LOCK indicator.
Warning Displays
L.BATT 155
4213567
MODEL
The LOW BATTERY warning is displayed when the
transmitter battery voltage drops below 9.3 volts, and a beeper
sounds. The operating time is still shown on the right. If you
reset this each time you charge the system, you will have a good
idea of how long you can safely operate.
WHEN THE BEEPER SOUNDS, LAND YOUR MODEL
AS SOON AS POSSIBLE BEFORE LOSS OF CONTROL
DUE TO A DEAD RECEIVER BATTERY.
IDLE On
The IDLE ON warning is displayed when the transmitter is
powered up with the Idle switch on in the helicopter mode only.
You can turn this off by moving the Flt. Mode switch or the
Flt. Cond. switch forward. If you switch the Flt. Cond. switch
and you get the HOLD ON alarm (see below), you must move
the Flt. Mode switch fully aft, then move the Flt. Cond. switch.
For your safety, the transmitter will not broadcast until this
alarm is ended.
HOLD On
The HOLD ON warning is displayed when the transmitter is
powered up with the Throttle hold switch on in the helicopter
mode only. You can turn this off by moving the Flt. Cond.
switch forward (this switch is on the top right, in the rear). If
you switch the Flt. Cond. switch and you get the IDLE ON
alarm (see below), you must move the Flt. Mode switch fully