User's Instructions

ManualsBrandsHitec RCD ManualsElectronicsR/C of Model Aircraft

Aircraft

(ACRO)

Section

– 55 –

6. If the right (CH1) elevon moves down with up elevator stick, change the its travel direction

by pressing the

Cursor Right

key (the little arrow moves under the 1), then press the

Data –

Decrease

key until you reach -50%. Otherwise, continue.

7. Now you’ll input the amount of aileron stick response on the right (CH1) elevon by pressing

the

Cursor Right

key once. Now the little arrows move both over and under the 1, and you

may adjust the amount of right elevon travel with the

Data +Increase

and

–Decrease

keys.

50% is a good starting point. As before, change the sign and use -50% if it travels the wrong

way with aileron stick.

SLV

MAS

8. Now you’ll input the amount of aileron stick response on the left (CH2) elevon by pressing

the

Cursor Right

key once. Now the little arrow moves under the 2, and you may adjust the

amount of left elevon travel with the

Data +Increase

and

–Decrease

keys. 50% is a good

starting point. Change the sign if travel needs to be reversed.

SLV

MAS

VTAL

— V-Tail Mixing

V-tail mixing is used with V-tail aircraft so that

both elevator and rudder functions are combined for

the two tail surfaces, called “ruddervators.” The

response to both elevator and rudder inputs can be

adjusted independently. However, if you program in too much elevator or rudder travel, when

both rudder and elevator are commanded the servos may reach their travel limits before full stick

motion has occurred. Therefore, you should keep the travel settings at 50% or below and adjust

the control linkages to get the travel you desire. Note that you cannot have both V-tail and

elevon mixing active at the same time.

Setting up V-Tail mixing

1. The right ruddervator should be plugged into CH2, and the left ruddervator should be

plugged into CH4.

2. Press one of the

Up Down Edit

buttons repeatedly to select the

VTAL

window. The

INH

indicator will show.

3. Press the

Active/Inhibit (Clear)

key to activate the V-tail function. The display will show On.







CH2

CH4

CH2

CH4

Up Elevator Left Rudder (view from rear)