User's Instructions
Glider
(GLID)
Section
– –
74
aileron motion. Normally, crow is set up so that the maximum control movements (maximum
drag) occur at "low" throttle stick position (towards the bottom of the transmitter). The Gear
switch must be forward for Crow to operate.
Setting Up Crow Mixing
1. Start by locating the CROW menu with the
Up Down Edit
keys. Either the
ON
or
OFF
display
will be flashing, depending on the position of the Gear switch (forward is on).
2. First set the CROW function activation point. Hit the
Cursor Left
key one time to get to the
SET menu. Now move the throttle stick all the way up. Enter that position by pressing the
Clear Active/Inhibit
key. The display should read a number around +125%.
SET +127
CH
16
SLV
MAS
ON
2
%
3. Make sure CROW is ON by moving the Gear switch forward. Verify by looking at the
flashing indicator.
4. Next, set up the throws for the ailerons. Press the
Right
key two times to get to the aileron
setting menu (a small arrow will appear over the number 1 in the display). Press the
Data
+Increase
or
–Decrease
keys to adjust the amount of UP aileron motion. Move the throttle
stick all the way down and be sure the ailerons go UP. If they don’t go up, but go down
instead, press the
Clear Active/Inhibit
key and then press the other Data key to achieve the
desired up aileron travel (this may depend on servo orientation). You'll probably want a fair
amount, but not all, of aileron travel. Be sure not to use full travel, so you'll have roll
authority while on approach in full crow command. Notice that you set the throw for both
ailerons at the same time: this is the reason to have identical control arm lengths and identical
neutral positions.
CROW + 35
CH
16
SLV
MAS
ON
2
%
5. Now press the R
ight
key to get to the elevator compensation menu (a small arrow will
appear over the number 2 in the display). Press the
Data +Increase
or
–Decrease
keys to set up
the throw for the elevator as desired. Move the throttle stick and be sure the elevator goes UP
with crow. If it goes down, press the
Clear Active/Inhibit
key and then press the other Data key to