User guide

Step 2: Attaching Control Linkages

Slide the control linkages through the middle hole in the control horns and then slide the locks over the

end of the linkage as shown above.

Step 2

Step 3: Main Wing Assembly

Slide the wing through the fuselage until prop-

erly positioned.

Step 3

While not necessary, you can apply

a small amount of CA glue to hold

the pieces permanently in place.

Step 4: Receiver Installation

Using the double sided tape, install the receiver

into the fuselage and plug the servo and ESC

leads into the appropriate channels.

Step 4: Battery Installation

Using the included Velcro strip, install the battery

into the front of the fuselage.

Step 4

Step 5

Step 5: Cutting the Control Surfaces

Before ying, you will need to cut the control

surface so they can move freely. Using a sharp

razor knife, cut only where indicated with

dashed lines in the above illustration.

Step 6