Data Sheet

INTEGRATED POWER SYSTEM

operation manual

Introduction:

Thank you for purchasing Hitec’s Energy Propel integrated Power System. Featuring a high

performance, high eciency brushless motor integrated with our Energy Rotor electronic speed

control! This combination creates an easy straighforward installation and clean wiring layout for

your multi-rotor

Connecting Your Motor:

1. Connect the power wires from the Motor to the power distribution board or battery.

2. Connect the signal cable to the ight controller according to the instruction.

Note: The red wire from the Motor should connect to the Positive + and black to the Negative (-)

side of the Power Distribution Board.

Power

Distribution

Board

Red

Black

Battery

Signal Wire

(white & black)

Power Wires

Energy Propel

Motor

180X & 22XX

Series

PAGE 1
80X & 22XX Series INTEGRATED POWER SYSTEM operation manual Introduction: Thank you for purchasing Hitec’s Energy Propel integrated Power System. Featuring a high performance, high efficiency brushless motor integrated with our Energy Rotor electronic speed control! This combination creates an easy straighforward installation and clean wiring layout for your multi-rotor Connecting Your Motor: 1. Connect the power wires from the Motor to the power distribution board or battery. 2.
PAGE 2
Model 1806/18 2204/18 Stator Diameter 18 mm 22 mm Stator Thickness 6 mm 5 mm Number of Poles 12N 14P 12N 14P KV Rating 2300 KV 2300 KV Resistance 0.161Ω 0.091Ω Idle Current 0.41A 0.73A Maximum Watts 180W 160W Input Voltage 2-3S LiPo 2-3S LiPo Shaft Diameter M5x11mm M5x11mm ESC Cont. Current 18 Amps 18 Amps ESC Burst. Current 28 Amps 28 Amps Recommended Prop Size 3 - 5 in 5 - 6 in Weight 35 g 33.5 g 2206/18 22 mm 7 mm 12N 14P 2200 KV 0.047Ω 0.96A 200W 2-3S LiPo M5x11mm 18 Amps 28 Amps 5 - 6 in 40.