Manual

Tools Required for Assembly

•#1PhillipsHeadScrewdriver•1.5mmHexHeadScrewdriver•13mmWrench

SECTION 2

Before Assembling the Extra 300S

Keep in mind when assembling and  ying the Extra 300S, that radio control model airplanes may cause injury

or property damage when improperly  own or mishandled. Always follow the warnings written in the instruc-

tion manual. Improper usage could lead to damage and/or failure of the electronic equipment. Be sure to read

this instruction manual in its entirety before assembling and  ying this model.

Step 1: Main Landing Gear Assembly

Usinga#1Phillipsheadscrewdriverandthefour

3.0 x 15 mm screws, attach the main landing gear

to the fuselage.

STEP 1

Step 3: Vertical Stabilizer Assembly

Gently slide the vertical stabilizer into the two slots

cut into the fuselage and lock it into place using

the two 2.6 x 12 mm screws.

STEP 3

Step 2: Horizontal Stabilizer Assembly

With the control horn facing down, slide the

horizontal stabilizer into place and attach to the

fuselage with the 4.0 x 40 mm machine screw.

STEP 2

Step 4: Connecting the Elevator Control Arm Linkage

Take one of the control linkages and slide the Z bend

through the middle hole of the elevator control horn.

Slide the other end into the swivel on the servo. Tighten

the screw just enough to hold the wire in position.

STEP 4

ASSEMBLY INSTRUCTIONS