RDX2 Pro Manual

1.) Connecting to a power source

The Hitec RDX2 Pro features a built-in switching power supply. You can connect the AC power cord

directly to an AC socket (100-240V AC) or use an 11-18V DC power source (such as an automotive

battery or 12 Volt power supply).

2.) Connecting the battery

NOTE: Before connecting any battery, it is absolutely essential to check one last time

that the parameters were set correctly. If the settings are incorrect, the battery may

be damaged and, in worse case scenarios, could even burst into  ames or explode.

3.) Balance Socket

The balance wire attached to the battery must be connected to the charger, with the black wire

aligned with the negative marking. Take care to maintain correct polarity. (See photo below)

This photo shows the correct way to connect your battery to the Hitec RDX2 Pro when charging in the

balance charge program mode.

Note

FAILURE TO CONNECT AS SHOWN IN THIS

PHOTO WILL DAMAGE YOUR CHARGER.

TO AVOID A SHORT CIRCUIT BETWEEN

THE CHARGE LEAD, ALWAYS CONNECT THE

CHARGE CABLE TO THE CHARGER FIRST,

THEN CONNECT THE BATTERY. REVERSE THE

SEQUENCE WHEN DISCONNECTING.

THE NEGATIVE BLACK LEADS SHOULD

ALWAYS BE JUSTIFIED TO THE RIGHT OF THE

CONNECTION.

Warning

Charger Connections