RDX2 Pro Manual

12
Battery Type Operation Operation Description
LiPo
Lilon
LiFe
LiHV
CHARGE
The charge mode is for charging LiPo/LiFe/LiIon/LiHV
batteries in normal mode.
DISCHARGE
This mode is for discharging
LiPo/LiFe/LiIon/LiHV batteries.
STORAGE
This program is for charging or discharging a lithium
battery which will not be used again for an extended
period of time.
FAST CHG
A fast charge will result in a smaller than usual charging
capacity but will reduce the total charge time.
BAL CHARGE
This mode is for balancing the voltage of LiPo battery cells
while charging.
Initial Setup of the Charger
After connecting the battery you are now ready to setup the charger to charge your speci c type of
battery. When the charger is  rst powered on, the last program selected will be displayed. If this
is not the battery you plan on working with then you will need to make changes to the operation
programming based on the following instruction.
BEFORE SELECTING AN OPERATION, IT IS CRITICAL THAT YOU KNOW THE
TYPE OF BATTERY YOU ARE WORKING WITH AND WHAT THE MANUFACTUR
ER RECOMMENDATIONS ARE FOR CHARGING OR DISCHARGING. FAILURE
TO FOLLOW THE MANUFACTURERS RECOMMENDATIONS CAN RESULT IN
DAMAGE TO THE BATTERY AND POSSIBLE EXPLOSION.
Available Operations
Depending on battery type, di erent operations will be available. This chart shows which operations
are available for the di erent types of batteries the RDX2 Pro is capable of working with.
Warning
Getting Started