RDX2 Pro Manual

Note

Once the battery is fully discharged, the screen will read

“END: CUTOFF-VOL” and the charger will emit an audible “ring”

sound. It will also display the Time Elapsed, End Voltage and

Capacity in mAh that was removed.

You can press the STOP button at any time during the

discharging process to stop discharging.

[TIME: 01:04:04]

NiMH RE-PEAK

NiMH 1.3A 6.42V

RPC 004:04 00686

NiMH/NiCd Battery Program

NiMH/NiCd Re-Peak Mode:

Applicable to NiMH and NiCd batteries only, in Re-Peak Mode,

the charger can top o the battery once, twice, or three times

in a row automatically. This process is good for con rming

that the battery is fully charged after it had been previously

charged and sitting for a while. A  ve-minute cool-down

delay occurs after each Re-Peak Charge.

NOTE: IN RE-PEAK MODE, THE RDX2 PRO

USES THE CHARGE AMPERAGE AND VOLTAGE

SETTINGS ENTERED IN CHARGE MODE.

After selecting the correct battery type, SCROLL to select the

‘RE-PEAK’ mode. Press the Jog Dial ENTER and the Re-Peak

cycle number 1 begins to  ash on the screen. SCROLL to adjust

the cycle count between 1 and 3.

Press and hold the START button for 3 seconds to start the

Re-Peak process.

Once the Re-Peak process has begun, the charger will display

the following real-time information: battery type, charging

current, battery voltage, RPC (Re-Peak Charge mode), elapsed

time and charged capacity.

Once the Re-Peak process is completed, the screen will read

“END: RE-PEAK” and the charger will emit an audible “ring”

sound.

It will also display the  nal voltage, and charged capacity.

BATTERY CHECK

.............

[END: CUTOFF-VOL]

[END: RE-PEAK]

5.00V 01980mAh

6.75V 00980mAh

[TIME:00:05:32]

NiMH RE-PEAK

*FLASHING

6.75V 00980mAh