RDX2 Pro Manual

29
This program is for NiMH/NiCd battery only.
When the charger detects the delta peak
value reaches the value you set, the charger
will say the battery is fully charged.
This program allows you to select whether or
not the RDX2 Pro beeps when you push buttons,
and if the buzzer sounds to alert you when a
charge/discharge operation is complete.
This program monitors the voltage of input
battery. If the voltage drops below the value you
set the operation is forcibly terminated to protect
the input battery.
Press and hold ENTER for 3 seconds to load
factory default settings.
It indicates the hardware and  rmware version.
Default: 4mV/Cell
3-15mV/Cell
OFF/ ON
10.0-12.0V
ITEM SELECTION DESCRIPTION
System Settings
A
NIMH SENSITIVITY
D. PEAK 4MV
A
NICD SENSITIVITY
D. PEAK 4MV
A
KEY BEEP ON
BUZZER ON
A
DC INPUT LOW:
CUT-OFF 11.0V
A
VERSION
HW: 1.00 SW: 1.00
A
LOAD FACTORY SET
ENTER