DPC-11 PC Servo Progammer Manual

13
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
Programming Your Hitec D Series
Servos
The following functions can be programmed
into the HITEC D Series servos using the DPC-11.
It is recommended that you program your
servos in the following order:
1. ID Setting
2. Direction of Rotation
3. Travel Speed (Slower)
4. Dead Band Width
5. Soft Start Percentage
6. Center and End Points
7. FAIL SAFE, On / O or Limp
8. Overload Protection (OLP)
9. Smart Sense On or O
10. Sensitivity Setting
1. ID Setting
With ID Setting you can number your servos with a
specic ID anywhere from 0-255. This can be helpful
when programming new servos or for use when
saving the parameters to a le.
DXXX Series Programming cont.