DPC-11 PC Servo Progammer Manual
16
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
Now you will setup the left and right end points.
When you have reached the desired end point, click
either the “LEFT” or “RIGHT” button to conrm your
setting. You will be notied when each one is set.
Once complete, click the OK button to exit the EPA
setup.
Resetting EPAs
To set or reset your EPAs to the factory defaults, click
on the “Setting” box under the EPA programming
section then click on “EPA_Reset.”
By choosing to use the Fail Safe function you will
need to set a preprogrammed travel point that the
servo will travel to in the event the servo loses signal
from the receiver.
7. Fail Safe On/O and Position
CAUTION – Program the Fail Safe point
after setting the center and end points,
otherwise it will change when you make
those settings.
WARNING
WARNING
To set the Fail Safe point, rst click “Fail Safe” under
the Program section.
DXXX Series Programming cont.