DPC-11 PC Servo Progammer Manual
17
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
Next move your servo to the desired position by
using the Manual positioning section as shown.
Once you have your desired Fail Safe position, click
on the “FS-Position” button Fail Safe Test as seen in
the illustration.
OLP is a “protection against servo damage” feature.
When a servo is at “full stall torque” and the servo
power amplier is sending the maximum power to
the servo motor, the OLP circuit will engage and
reduce the power being sent to the motor. This act of
power reduction could help prevent a critical failure
of one or more servo components. When the servo
is fully stalled, the OLP circuit will reduce the power
from the servo amp to the servo, by the percentage
selected. Selecting a value of 20%, will reduce the
power sent to the motor by 20%. This eectively
reduces the servo power to 80% of its potential. The
factory default setting is always “OFF.”
8. Overload Protection (OLP)
DXXX Series Programming cont.
Fail Safe Limp Mode
Clicking the FS_Limp box causes the servo to go
limp in the event signal is lost and the servo will not
have anyholding power to maintain it’s position.