DPC-11 PC Servo Progammer Manual

DPC-11

Universal Programming Interface

for Hitec Programmable Servos

Test Functions Testing a servo’s function can be critical to

completing a successful project. Use these tests

to “burn-in” new servos or to check for broken

gears and other issues. The DPC-11 is capable of

performing the following tests:

1. Servo Travel, using one of the following

methods:

a. Manual Positioning

b. Automatic Sweep Positioning

c. Step Positioning

2. FAIL SAFE programming position

Programming Functions The following functions can be programmed

into the HITEC BLDC servos using the DPC-11:

1. FAIL SAFE, On or O

2. Direction of Rotation

3. Travel Speed (Slower)

4. Center and End Points (EPAs)

5. FAIL SAFE Position

6. Dead Band Width

7. Soft Start

8. “Save and Open” Parameter File

9. Load Factory Default Parameter File

Connecting Your Servo It is recommended that you connect your DPC-

11 in the following order for proper operation:

1. Connect DPC-11 to your PC computer

2. Launch the DPC-11 software

3. Connect your servo

4. Connect your battery

Now click the “Connect” button in the

DPC-11 software. If your connections

are correct, you should see the

following screen:

HSB-9XXX Servo Programming cont.