DPC-11 PC Servo Progammer Manual
24
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
2. Travel Speed
This feature is useful for users who do not have
servo speed control functions on their transmitter.
Reducing the travel speed is a nice feature to slow
down aircraft landing gear retracts. The servo
speed function will only slow a servo down. You
cannot make a servo travel faster than its rated
speed. You can adjust the servo’s travel speed in ten
proportional steps from a minimum speed (10%) up
to its maximum speed (100%).
3. Dead Band Width
Some applications, such as using multiple servos on
a single control surface, may require you to change
the center “Dead Band” to prevent the servos from
ghting each other. Users can adjust the center point
“Dead Band Width” to one of ve choices, with 1
being the most sensitive and 5 the least sensitive.
4. Soft Start Setting
The soft start setting allows users to set how fast the
servos react when rst powered on. Using a slower
soft start setting can prevent damage to your model
by slowly moving the servo into position. Default
Setting is 20% (slowest). There are ve setting from
20% to 100%, which is instantaneous reaction.
NOTE – This setting has no eect on
the reaction speed of the servo once it is
powered up.
WARNING
WARNING
HSB-9XXX Servo Programming cont.