DPC-11 PC Servo Progammer Manual

25
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
5. Center & End Point Setting (EPA)
With the EPA setup, users can customize the center
point and left/right servo travel end points. This can
be helpful to ne tune your model’s control surfaces.
To set the Center and Endpoints, click on the
“Setting” box under the EPA programming section.
6. Resetting EPAs
To set or reset your EPAs to the factory defaults, click
on the “Setting” box under the EPA programming
section. Then click EPA Reset.
NOTE – You can slide the adjustment bar to move
in larger steps. You can click the arrows “< >” on each
end to make single point adjustments, or you can
click on the white space of the adjustment bar to
move it in 10 point increments.
WARNING
WARNING
The rst setting is the center point, click “OK” to
continue. You can adjust the center point using three
dierent methods.
When you have reached your desired center point,
press okay to continue. You will now be prompted
to setup the Left and Right End Points. To setup the
left and right end points, click “OK” when prompted
by the pop-up screens. Just like with the center
point, you can adjust them in the same manner with
the only exception being that clicking on the white
space of the adjustment bar moves it in increments
of 5 points.
HSB-9XXX Servo Programming cont.