DPC-11 PC Servo Progammer Manual
28
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
2. Load a File
To load a parameter le, click on “OPEN”, navigate to
the location you have stored your le, and click on
the le name you want to open. You will get the “File
load has completed” prompt. Click “OK.” Now click
“Write All” to load the setting into the servo. Once
you see the “Write All completed” message, click “OK.”
The parameters have been written to the servo.
3. Restoring Factory Defaults
To restore the servo to the factory default setting,
click on “OPEN” and navigate to the directory in
which you unzipped the DPC-11 software download.
In the directory, “Factory Defaults,” you will nd
the les for each servo model. Click on the le that
matches the servo you want to restore and click on
“Open.” Once you see the le load has completed
message, click OK. Now click “Write All” to load
the setting into the servo. Once you get the “Write
all completed” message, click “OK.” The default
parameters have been written to the servo.
CAUTION – Restoring a factory default le other
than the one specically made for your servo model
may result in undesired operation.
WARNING
WARNING
HSB-9XXX Servo Programming cont.