DPC-11 PC Servo Progammer Manual

DPC-11

Universal Programming Interface

for Hitec Programmable Servos

NOTE – The FAIL SAFE point must be set by the

user in the programming section under setting the

FAIL SAFE Point.

WARNING

FAIL SAFE Test

Programming your HS-5XXX/7XXX

Series Servos:

NOTE – To make your changes

permanent you must “write” the

programming to the servo by cycling.

WARNING

This feature tests the user programmed FAIL

SAFE point of your servo.

By clicking the START button, the servo will

travel to its preset Fail Safe position.

The following functions can be programmed

into the HITEC D Series servos using the DPC-

11. It is recommended that you program your

servos in the following order.

9. Direction of Rotation

10. Resolution (HS-7XXX Series)

11. Travel Speed (Slower)

12. Dead Band Width.

13. Overload Protection (HS-7XXX Series)

14. Center and End Points (EPAs)

15. FAIL SAFE Position

1. Direction of Rotation

Normal servo rotation based on 900 - 2100µs input

signal is clockwise from left to right. You can change

this to counterclockwise by clicking on the Direction

of travel button as shown. The direction is shown as

CW for clockwise and CCW for counterclockwise.

HS-7XXX/5XXX Series Programming cont.