DPC-11 PC Servo Progammer Manual

33
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
2. Resolution (HS-7XXX series)
This feature allows a choice of high or normal
resolution for HITEC HS-7XXX Series digital servos.
In “High Resolution Mode”, the servo travels within
a 120 degree angle, which allows the servo to move
in smaller “steps”, or at a “ner” level of resolution
for extraordinary precision applications. In “Normal
Resolution Mode”, the servo travel is a wider 180
degree angle, resulting in larger range of motion
delivering coarser “steps”. This allows a wider range
of travel, but at the cost of the very ne resolution
provided by the high resolution mode.
3. Travel Speed
This feature is useful for users who do not have
servo speed control functions on their transmitter.
Reducing the travel speed is a nice feature to slow
down aircraft landing gear retracts. The servo
speed function will only slow a servo down, you
cannot make a servo travel faster than its rated
speed. You can adjust the servos travel speed in ten
proportional steps from a minimum speed (10%) up
to its maximum speed (100%).
4. Dead Band Width
Some applications, such as using multiple servos on
a single control surface, may require you to change
the center “Dead Band” to prevent the servos from
ghting each other. Users can adjust the center point
“Dead Band Width” to one of ve choices with 1
being the most sensitive and 5 the least sensitive.
HS-7XXX/5XXX Series Programming cont.