DPC-11 PC Servo Progammer Manual

8
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
4. Once installation is complete, you will
see the “Success” screen. Now click “OK”
to close the program.
5. Plug in the USB cable to your computer
and then into the DPC-11. Windows
should locate the driver and install it
automatically.
6. Once it is installed you can launch the
DPC-11 Software from the icon on your
desktop.
NOTE – It is imperative that you use a USB 2.0
compliant cable to connect your DPC-11 to your
computer. Non-compliant cables will cause erratic
operation or may not work at all.
WARNING
WARNING
Driver Installation
for 64bit Operating Systems
(Windows 7, 8, 10 and XP)
NOTE – It is imperative that you use a USB 2.0
compliant cable to connect your DPC-11 to your
computer. Non-compliant cables will cause erratic
operation or may not work at all.
WARNING
WARNING
1. Plug in the USB cable to your computer
and then into the DPC-11. Windows
should automatically nd and load the
correct driver.
2. Once installed, launch the DPC-11
Software from the icon on your desktop.
NOTE – If the driver does not install automatically,
refer to the 32bit Installation instructions to
manually install the driver.
WARNING
WARNING
Installation: Driver cont.