DPC-11 PC Servo Progammer Manual

9
DPC-11
Universal Programming Interface
for Hitec Programmable Servos
DXXX Series Programming
Introduction
NOTE – If you always want the DPC-11 software to
launch in D-Series Mode you can change the start
window setting in the upper left hand corner of the
window.
WARNING
WARNING
The DPC-11 Programming Software gives
the user unparalleled ability to adjust the
parameters of the Hitec DXXX series of Digital
Programmable Servos. Additionally users can
test their servos, save parameters to a le, load
parameters from a le and restore the factory
settings. To program your D Series servo, launch
the DPC-11 software from the desktop icon and
select D-Series from the startup menu.
User Interface The main screen of the D series programming
interface is broken into four sections,
Connection, File Operations, Testing and
Programming.
Change what window is shown when
launching program.
Connects or reconnects servo.
Takes you back to the main menu.
File operation section.
Testing section.
Programming section.
Section 3
DXXX Series Programming