Data Sheet

15
BATTERY TYPE OPERATION OPERATION DESCRIPTION
LiPo,
LiFe,
LiIon,
LiHV
Charge
The charge mode is for charging LiPo/LiFe/Li-Ion/ LiHV
batteries in normal mode.
Discharge
This mode is for discharging LiPo/LiFe/LiIon/LiHV batteries.
Storage
This program is for charging or discharging a lithium battery
which will not be used again for an extended period of time.
Fast Charge
A fast charge will result in a smaller than usual charging
capacity but will reduce the total charge time.
Balance
This mode is for balancing the voltage of
LiPo battery cells while charging.
NiMH,
NiCd
Charge
The charger will charge NiMH and NiCd batteries using the
charge current set by the user.
Auto Charge
In this program, the charger detects the condition of the
connected battery and automatically charges the battery.
NOTE: You should set the upper limit of the charge current
to avoid damage by excessive charging current. The Power
Peak E7 may not be able to detect the charge capacity of low
resistance batteries.
Discharge
This mode is for discharging a NiMH/NiCd battery.
Re-Peak
In re-peak charge mode, the charger can peak charge the
battery once, twice, or three times in a row automatically.
This is good for conrming the battery is fully charged and for
checking how well the battery receives fast charges.
Cycle
Automatically charges/discharges the battery up to 5 times.
This process can enhance the performance of
NiMH/NiCd batteries.
Pb
(Lead Acid)
Charge
This mode is for charging a Pb battery using the charge current
set by the user.
Charge
This mode is for discharging a Pb battery using the charge current set
by the user.
Press and hold the START/ENT button until the charge selection screen is displayed like one of the
examples shown below and on following page.
[ 01 ] Memory Name...
LiPo 7.4 V 200mAh
Charge :
Discharge :
Storage :
Fast Charge :
Balance :
[ 02 ] Memory Name...
NiMH 4Cell 2100mAh
Charge :
Auto Chg :
Discharge :
Repeak :
Cycle :
Lithium Battery Process Screen NiMH/NiCd