User's Manual

• ClickontheCommunicationtabwithinClassComm.Thiswilldisplaythecommunicationgridas
shown.IfpressinganykeysonthePebblePadhandsetsshowaredLED,thenthathandsetisnot
MAPPEDtothereceiverandwillnotcommunicate.
PressanykeysonthehandsetsandacellwilllightupintheCommunicationgrid.
Thesoftwareisnowinstalledandthehardwareisconguredcorrectly
andhasbeentestedinthecommunicationareaofClassComm.
Connectthereceiverandtesthandset
communicationwithinClassComm
Press and hold the -/? key within
5-10cm of the connected receiver.
The communication LED will blink
GREEN 3 times when mapping is
complete.
A non-mapped handset will show a
red light when any key is pressed.