User Manual

15/31
V1.0
8 The modem is operating properly if the Power, RF/DS, RF/US, Status and USB light
emitting diodes (LEDs) are solid green (lit and not blinking).
9 You must now install the software drivers provided on the Installation CD. Be sure to
follow the instructions (below) for your specific operating system.
USB Driver Installation
After the Hardware Installation, you must install the USB software driver.
Windows 98
After the Hardware Installation, the window “Found New Hardware” appears. Please follow the
instruction in “Add New Hardware Wizard”
1. Select Search for the best driver for your device (Recommended) and click Next.
2. Check the Specify a Location check box. The location of the driver file is :
D:\Drivers\Generic_Compact_CM_USB
where D is the letter of your computer's CD-ROM drive.
If necessary, replace D with the letter of your computer's CD-ROM drive. You can either click Browse
to locate the driver file, or type D\Drivers\Generic_Compact_CM_USB into the field next to the
Browse drop-down list.
3. Click Next to search for the necessary driver files.
4. Select The updated driver (Recommended) and click Next. When the system locates the driver files,
click Next to automatically install the necessary files.
5. When prompted, insert the Windows 98 SE CD into the CD-ROM drive and click OK.
6. After Windows copies the necessary system files, click Finish. The system Settings Change dialog
box appears.
7.
Click Yes to reboot your computer.
8.
Make sure the LED of Power, Cable, Status and USB are green without blinking, which means the
installation is finished. Please refer to Chapter 5: “
Cable Modem Front and Rear Panel” for
more information.
Windows 2000/XP
The Found New hardware Wizard screen appears.
1. Select Search for a suitable driver for my device (Recommended) and click Next.
2. Check the CD-ROM drives check box and click Next to search for the necessary driver files. The
location of the driver files is:
D:\Drivers\Generic_Compact_CM_USB
where D is the letter of your computer's CD-ROM drive.
3. When the Found New Hardware Wizard displays the search results, click Next to install the
necessary driver files.
Note: If the Digital Signature Not Found screen appears, click Yes to continue the installation.
4. When the Found New Hardware Wizard completes the installation, click Finish.
5. Make sure the LED of Power, Cable, Status and USB are green without blinking, which means the
installation is finished. Please refer to Chapter 5: “
Cable Modem Front and Rear Panel” for
more information.