Quick Start Guide

ManualsBrandsHitron Technologies ManualsElectronics24X8 P6 DBCC WiFi eMTA

QUICK START GUIDE

HITRON

CGNV5

Connect to the Internet

Connect phone

Configure wireless network

Read me

First!

STEP

Check the contents of the packaging

Look into the box and make sure you have the followings:

Connect the cable port

STEP

Turn on the power

Connect the power adapter to the POWER port.

STEP

User comfigurations (optional)

QUICK START GUIDE

CGNV5

ETHERNET CABLE

POWER ADAPTOR

Use the Ethernet cable that came with the device to connect your

computer to one of the LAN ports.

Use the telephone cable to connect your telephone to the

TELEPHONE port and wait for dial tone before using.

Connect your computer to the device

Connect the phone to the voice port

Connect your computer to wireless network

Your device has a configuration interface that allows you to

completely control the behavior of the device. In a web browser,

enter the IP of the device in the address bar and make sure your PC

is on the same subnet as the device. On the screen that appears,

enter username and password.

Device IP:

Modo Router: 192.168.0.1

Mode Bridge: 192.168.100.1

STEP

Connect the wireless devices with SSID and correct password. If

you have not changed them, the default values are indicated on

the sticker at the bottom of the device.

Connect your wireless devices by WPS. Access the configuration interface (see

step 6), go to the Wireless page to enable WPS and set AES encryption mode,

then press Save changes.

Connect the coaxial cable from the cable outlet to the CABLE port.

STEP

Input:12Vdc ,2.5A

Made in China

User name:

XXXXX

Password:

XXXXXXXXX

P/N:1234567890AB

Model :ABCDEFGH

Web address:

Press this button to start the procedure for setting

up WPS (PBC). Press PBC button of your wireless

clients within coverage area in two minutes to

allow joining the wireless network.

0440010341N0

2.4G 5G

2.4G SSID:YZ1234567890

5G SSID:YZ1234567890

PassPhrase: 9876543210YZ

Summary of content (3 pages)

PAGE 1
QUICK START GUIDE Check the contents of the packaging STEP HITRON CGNV5 Read me First! 1 Look into the box and make sure you have the followings: Connect to the Internet CGNV5 Connect phone Connect the cable port 2 Connect the coaxial cable from the cable outlet to the CABLE port. Connect the phone to the voice port STEP 4 Use the telephone cable to connect your telephone to the TELEPHONE port and wait for dial tone before using.
PAGE 2
Installation complete STEP 8 Congratulations! You have successfully setup your CGNV5. If you have any problem, see the next section for help to identify the cause. IP addresses If the CGNV5 is correctly connected to the network (see LED Display) but connected computer cannot access to the Internet, the IP address of your computer may not be configured correctly.
PAGE 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.