User's Manual

3. Test HT-GDS1
Test HT-GDS1 from the desired location
before permanently installing it by flipping
it forward as shown above, this is the same
action as the garage door opening. Check
if is reporting a close or open
message from both orientations.
4. Install HT-GDS1
Install HT-GDS1 on a clean surface by using
double side tape or screws.
5. Close HT-GDS1’s housing
Once you have confirmed is
communicating, install it in its mounting
plate on the garage door
HT-GDS1
HT-GDS1
Tape
Screw
Mounting plate
Screw
holes
Open/ Close
Test
Install
Alignment
Flip
Top cover
Where not to place
(1) Metal can reduce transmission range
(2) Damp or Rain or very humid area
(3) Over 50 C or Below -10 C
o o