Quick Start Guide

FCC STATEMENTS
FCC STATEMENTS
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries
According to the Instructions.
The cable distribution system should be grounded (earthed) in accordance with ANSI /
NFPA 70, National Electrical Code (NEC), in particular Section 820.93, Grounding of
Outer Conductive Shield of a Coaxial Cable.
Unambiguous reference to service documentation for instructions for replacement of
fuses replaceable only by service personnel.
For telecommunication type connectors and terminals not used for connection to the
telecommunication network should be provided with a marking identifying the specific
function or circuit characteristic the connector or terminal is used for.
ATTENTION:
Il y a risque d’explosion si la batterie est remplacée par une batterie de type incorrect.
Mettre au rebut les batteries usagées conformément aux instructions.
le système de distribution par câble doit être mis à la terre ( la terre) conformément à la
norme ANSI / NFPA 70 , National Electrical Code ( NEC ), en particulier l'article 820.93 ,
la terre du blindage conducteur extérieur d'un câble coaxial.
Référence sans ambiguïté à la documentation de service pour obtenir des instructions
pour le remplacement des fusibles remplaçables par un personnel de service.
Pour les connecteurs de type de télécommunication et les terminaux ne sont pas
utilisées pour le raccordement au réseau de télécommunication doivent être pourvus
d'un marquage d'identification de la fonction spécifique ou une caractéristique du
circuit du connecteur ou d'un terminal est utilisé pour.
FCC STATEMENTS
cUL
LISTED
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with
any other antenna or transmitter except in accordance with FCC multi-transmitter
product procedures.
For operation within 5.15 ~ 5.25GHz / 5.47 ~5.725GHz frequency range, it is restricted to
indoor environment. This device meets all the other requirements specified in Part 15E,
Section 15.407 of the FCC Rules.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
40cm between the radiator & your body.