Model # HT-EMN3 Quick Install Guide WiFi Extender
Step 1: What’s in the Box Look in the box and make sure you have the following: Power Supply HT-EMN3 WiFi Extender Cat 6 Ethernet Cable Quick Install Guide Step 2: Locate your Gateway If you have a pre-installed Hitron gateway, the gateway will automatically setup your new HT-EMN3. When connected, the AutoSync feature takes about 2 mins. (CODA Gateway pictured) HT-EMN3 WiFi Extender Gateway If you set up a HT-EMN3 with a non-Hitron gateway, the gateway might not support auto-setup.
Method A: Connect the HT-EMN3 with an Ethernet Cable Use the Ethernet cable provided to connect the LAN port to one of the LAN ports on the Hitron Gateway. (CODA Gateway pictured) Go to step 4 Cat 6 Ethernet Cable HT-EMN3 WiFi Extender Gateway Method B: Connect the HT-EMN3 to a Cable Outlet (MoCA) Use a coaxial cable (not included) to connect your HT-EMN3 CABLE connector to a coaxial outlet. The coaxial outlet and your gateway must be on the same coaxial network.
Method D: Wi-Fi to Wi-Fi Setup via WPS Use the power cord to connect the POWER port to a power outlet. (see Step 4 picture) 1 Login to the gateway web page and turn on WPS. 2 Press the WPS button on the Gateway. 3 Press the WPS button on the back of the HT-EMN3. The HT-EMN3 WPS LED will start blinking. WPS LED will become steady when active and ready. Your HT-EMN3 is ready (don’t do Step 4).
Step 5: How to Best Place your HT-EMN3 1 MoCA or Ethernet Place in an area where your existing gateway does not provide good Wi-Fi coverage. Must be on the same coax or Ethernet network as the gateway to work properly. 2 WiFi to WiFi The HT-EMN3 must be placed where it receives strong Wi-Fi signal from the gateway. If not, performance will degrade. Look at the WPS LED indicator to witness wireless signal strength (see below notes).
LEDs Power Green when powered on. MoCA Blue high-speed mode. Green low-speed mode. Off if not connected to another MoCA device. Ethernet .Green for Ethernet connection. Wireless 2.4GHz 5GHz WPS Green when 2.4GHz WiFi on Green when 5GHz WiFi on Green when WPS on WARNING Risk of electrical shock. Do not expose the device to water or moisture. The device is a high-performance communications device designed for home and office environments. Do not use the device outdoors.
FCC CAUTION Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor environment only. This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
Quick Install Guide - HT-EMN3 - WiFi Extender
