User Manual

9 2
When repairing or replacement of parts is required, make sure the service technician
has used the parts/components specified by the manufacturer or parts/components
that have the same characteristics as the original parts/components. Unauthorized
substitutions may result in risk of fire, electric shock or other hazards.
POWER SOURCE
Before connecting this product with AC outlet, do check and make sure the electric
supply voltage is as same as it is marked on the rear panel of this product.
WARNING: It's very dangerous to insert a power plug that has bare wire into an AC
outlet.
DECLARATION
This product does not contain any parts or components that can be repaired by users
themselves. If there is any malfunction, refer to this instruction or ask for repair by a
qualified service technician. Do not try to repair by yourself, otherwise the
manufacturer will not be responsible for any consequences resulted there from.
Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE 1:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2:
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
FCC Warning
After-Sales services
If you still could not resolve your issue, please contact the seller for customer service.
Notice
1. Using the same type or similar type of battery, otherwise it may cause explosion.
2. Keep the battery away from sunlight, heat or fire.
3. Please remove batteries from the remote, if it is not used for a long time.
4. If the battery is aged, the effective control distance of the remote will be less.
Change the battery when this happens.
5. Please abide by your local regulations when discarding the battery. Please do not
discard the battery along with other rubbish.
6. This icon means this product is a CLASS II device or it comes with double
insulation. It does not need earth lead.
7. This icon means this product is only suitable for indoor use.