User manual

Network Bullet Camera·Quick Start Guide
26
26
8. (Optional) Install the water-proof jacket for network interface.
Refer to Section 2.5 for detailed installation procedures.
2.3.2 Mounting with a Junction Box
Before you start:
The junction box is not included in the package. You need to prepare
one for this mounting type.
Steps:
Junction Box
Safety Rope
Figure 2-14 Mounting with a Junction Box
1. Attach the drill template (supplied) to the wall where the camera
is to be mounted.
2. Drill holes in the wall according to Hole 2 on the drill template.
See Figure 2-11.
3. If you need to route cables through the wall (or the ceiling), cut a
cable hole according to the drill template. Skip this step, if you
want to route the cables on the surface of the wall (or the ceiling).