User manual

Network Bullet Camera·Quick Start Guide
13
13
4. (Optional) Install the water-proof jacket for network interface.
Note:
It is recommended to adopt the water-proof jacket (supplied) for
the network interface when the camera is installed outdoor.
1). If the network cable has been settled down, cut off the plug of
the network cable first.
2). Route the network cable through the following components in
sequence: fix nut, water-proof ring, and the main body of the
water-proof jacket, as shown in the figure.
3). Insert the water-proof ring into the main body of the
water-proof jacket, to increase the sealing ability of the
components.
4). Wire the plug and network cables up.
5). Fix the O-ring to the network interface of the camera, and
then connect the network cables.
6). Wrap the network interface with the main body of the
water-proof jacket, and then rotate the fix nut clockwise to
assemble it to the main body of the water-proof jacket.
Network Interface
O-ring Plug
Water-proof Jacket Water-proof Ring Fix Nut Network Cable
Figure 2-4 Install the Water-proof Jacket