User manual

Network Bullet Camera·Quick Start Guide
14
14
Wall Mounting with a Junction Box
1. Drill the screw hole and cable hole according to the supplied drill
template (shown as Figure 2-1).
2. Align the screw holes of the junction box to the drill template, and
fix the junction box to the wall with screws.
3. Route the cables.
4. Fix the camera to the junction box with screws.
5. Adjust the view angle. For details, refer to Step 3 in Chapter 2.1.
6. (Optional) Install the water-proof jacket for network interface. For
details, refer to Step 4 in Chapter 2.1.
Drill Template
Figure 2-5 Installation with a Junction Box