User manual

User Manual of Network Video Recorder
101
7.8 Configuring Advanced Settings
7.8.1 Configuring Cloud P2P
Purpose:
Cloud P2P provides the mobile phone application and as well the service platform page to access and manage your
connected NVR, which enables you to get a convenient remote access to the surveillance system.
 If PPPoE function is disabled, enabling the cloud P2P will lead the UPnP function to be enabled.
 Among cloud P2P and DDNS, only one can be enabled.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the Platform Access tab to enter the Cloud P2P Settings interface.
3. Check the Enable Cloud P2P checkbox to activate this feature.
4. If required, select the checkbox of Custom and input the Server Address.
The default server address is dev.hicloudcam.com.
5. To turn the Enable Stream Encryption on, you can select its checkbox.
6. Enter the verification code of the device.
The verification code consists of 6 capital letters and is located at the bottom of the DVR. You can also use the
scanning tool of your phone to quickly get the code by scanning the QR code below.
Figure 7. 17 Cloud P2P Settings Interface
7. Click the Apply button to save and exit the interface.
After configuration, you can access and manage the NVR by your mobile phone on which the Cloud P2P
application is installed or by the website (http://www. hicloudcam.com).
For more operation instructions, please refer to the help file on official website (http://www.hicloudcam.com).
7.8.2 Configuring DDNS
Purpose:
If your NVR is set to use PPPoE as its default network connection, you may set Dynamic DNS (DDNS) to be used
for network access.