User manual

Network Speed Dome·Quick Start Guide
8
2 Setting the Dome over the LAN
You shall acknowledge that the use of the product with Internet access might be under network
security risks. For avoidance of any network attacks and information leakage, please strengthen
your own protection. If the product does not work properly, please contact with your dealer or
the nearest service center.
2.1 Wiring
To view and configure the speed dome via LAN (Local Area Network), you need to connect the
network speed dome in the same subnet with your PC. Then, install the SADP or client software to
search and change the IP of network speed dome.
The following figure shows the cable connection of network speed dome.
Network
Speed Dome
Switch
Internet
NVR
PC
Figure 2-1 Wiring Over a LAN
2.2 Activating the Speed Dome
Purpose:
You are required to activate the speed dome first by setting a strong password for it before you can
use the speed dome.
Activation via Web Browser, Activation via SADP, and Activation via client software are supported. In
the following sections, activation via web browser and SADP will be taken as examples. You may
refer to the user manual of the speed dome for the details of activation via client software.
2.2.1 Activation via Web Browser
Steps:
1. Power on the speed dome, and connect the speed dome to the network.
2. Input the IP address into the address bar of the web browser, and click Enter to enter the
activation interface.