User manual

Network Speed Dome·Quick Start Guide
5
Figure 1-8 Tighten the Lock Screws
7. Remove the protective film on the IR light.
The protective film may vary according to the models.
Mini IR Speed Dome Type II
Steps:
1. Drill holes in the ceiling.
1) Attach the drill template to the ceiling where you need to install the speed dome.
2) Cut a hole and drill screw holes according to the drill template.
±2mm of the diameter of the circle is tolerable.
Figure 1-9 Drill Template
2. Route the cables through the ceiling for the speed dome.
3. Install the bracket.
1) Place the in-ceiling bracket on the speed dome according to the direction of the arrow in
the figure below.
2) Rotate and tighten the 3 AM6 screws on the bracket to fix the bracket with the speed
dome as shown in Figure 1-30.