User manual

Network Speed Dome·Quick Start Guide
2
1.2 Wall Mounting
1.2.1 Installing the Bracket
 The speed dome can be installed to a thread interface or non-thread interface bracket. The
non-thread bracket is highly recommended.
 When you select a thread bracket, please install the pendent adapter (supplied) between the
bracket and speed dome. Any mismatch problems shall be taken responsibility by the user.
 The dimension of pendant adapter is G1
1
2
.
 For cement wall, you need to use the expansion screw to fix the bracket.
 For wooden wall, you can just use the self-tapping screw to fix the bracket.
 Please make sure that the wall is strong enough to withstand at least 8 times the weight of the
dome and the bracket.
 The wall must be thick enough to mount the expansion screws.
There are several ways to install the speed dome. In this section, the non-thread bracket installation
is taken as an example. Refer to the following steps for details:
Steps:
1. Get the bracket and screws from the packing box as shown follows.
Figure 1-2 Wall Mounting Bracket and Accessories
2. Drill 4 φ12 screw holes in the wall according to the hole locations of the bracket, and then insert
M8 expansion screws into the screw holes.
Figure 1-3 Drill Screw Hole and Insert Expansion Screw
3. Secure the bracket with 4 hex nuts and washers.