User manual

HD-TVI Speed Dome·Quick Start Guide
4
The speed dome is self-adaptive to private protocol when the No.8 and 9 switches are both
OFF.
 TVI Mode
For convenient settings, refer to the following list to set the TVI mode of the speed dome.
Table 1-6 TVI Mode
Switch No.
TVI Mode
10
V2.0
OFF
V1.0
ON
 Terminal Resistor
Table 1-7 Terminal Resistor
Switch No.
1
2
Turn on the Resistor
ON
ON
Turn off the Resistor
OFF
OFF
1.3 Wiring and Installation
There are several ways to install the speed dome. The wall mounting is taken as an example below.
1.3.1 Wiring
The survey of the actual installation environment and planning the wiring is highly recommended
before the accurate deployment of the wire is implemented in order to provide a safe and steady
power supply and a reasonable wiring route.
 Get familiar with the installation environment before deploying the wire, including the wiring
distance, surrounding, and electromagnetic interference and so on.
 Please choose the cable with nominal voltage higher than the actual voltage, to ensure a
normal running in case of unsteady voltage.
 To protect the power cable and the signal transmitting cable from human tampering, you
should pay attention to the protection and reinforcement of the cables.
 When deploying the wire, please do not tighten the wire or make the wire loose.
The wiring of the speed dome should be performed by professionals.
1.3.2 Installing the Bracket
Before you start:
Wall mounting is applicable to the indoor/outdoor solid wall construction. The followings are the
mandatory precondition for wall mounting: