Operating Manual

Table Of Contents

Mobile terminal operating manual

Set the 2.4G wireless SSID in "Extended 2.4G", set the 5.8G wireless SSID in

"Extended 5G", and set the wireless password in "Wi-Fi password" (as shown in Figure

15).

6.Mode description:

(1) Repeater:

The repeater mode refers to amplifying the original Wi-Fi signal and then transmitting a

new Wi-Fi signal (the new signal name can be the same as or different from the original

Wi-Fi signal) , endlessly expand your wireless network to cover large areas and improve

performance.

(2) AP mode:

AP mode: Wireless access point mode is a working mode that converts wired to Wi-Fi

wireless. It is usually used in an environment where only wired access has no Wi-Fi

signal in the current environment.

Settings: Insert the network cable into the network interface of the device, select “AP

mode” of the “Work mode” (as shown in Figure 14), and click [Next] to enter the

“Wireless Configuration” page. Set the 2.4G wireless SSID in "Extended 2.4G", set the

5.8G wireless SSID in "Extended 5G", and set the wireless password in "Wi-Fi

password" (as shown in Figure 15). After clicking [Save], the device will restart and

apply the new configuration work (as shown in Figure 16). In AP mode, the device

indicator will be blue when the start-up is complete.