Instruction Manual

Copyright HK Instruments 2023 www.hkinstruments. Installaonversion4.02023
STEP 3: INSTALLATION - MOUNTING THE PROBE MOUNTING THE PROBE continued
Figure 1 - Mounng
Figure 2 - Air ow direcon
1)CheckthatthesizeoftheFloXact™probecorrespondswiththe
ductorterminaltowhichitisgoingtobeinstalled.
2)Drillaø25mmholeintotheduct
3)PlacetheFloXact™probe(s)intotheductthroughthehole.
6)ConnectthetubesfromtheFloXact™pressureinletstotheinletin
thepressuretransmier.Connecttheplustubetotheplusinletand
theminustubetotheminusinlet.
• IfmorethanoneFloXact
TM
probesused,uset-hoseconnectorto
connecttubesfromseparateprobes.
5)Aachtheprobe(s)intotheductwithtwoscrews.
Figure 3 - Aaching with screws
• Forroundducts,werecommendinstallingtheFloXact™probe
horizontallyintheduct.
4)Checkthatairowdireconintheductcorrespondswiththe
indicaonontheFloXact™probe.
Figure 4
FloXact
TM
-Lmounng
FloXact
TM
-Rmounng
When do I need more than one probe? – Check step 1.
• Fornonstandardapplicaons,pleasecontactyournearest
distributororthefactory.
FloXact
TM
-Rmounngwithtwoprobes.