www.hkc-eu.
We will not have any further notice in case of any change of the product specifications. Before operation, please read this User Manual carefully.
Safety Precautions and Maintenance 1. Before cleaning, always unplug your monitor. It is recommended to use dry cloth or lightly damp cloth to clean your monitor. Dry cloth is, however, the safest. If using damp cloth, wait for your monitor to completely dry before plugging it in again. 2. Do not use alcohol or ammonia-based cleaner and/or liquids to clean your monitor. 3. This monitor features ventilation openings on the back of the unit.
Basic Setup 1. Insert one end of the HDMI cable into your PC's graphics card. DVI, VGA, or display port (DP) may also be used. These cables are not included. Note: For optimal refresh rate (or "performance") at 144hrz, it is recommended to use a Display Port (DP) or DVI-D dual link cable with the monitor's corresponding connector. 2. Connect the other end of the video cable to the corresponding connector on your monitor. See the image below.
Control Panel The Control Panel is located at the corner of the monitor. Its labels are on the front of the monitor while its buttons are directly under the labels on the bottom edge. The Control Panel is used (1) to turn the monitor on and (2) in combination with the On-Screen Display (OSD) Menu to adjust the monitor settings. Review the images below for information about this panel.
V.
Main Menu Item Main Menu Icon Submenu Item Main Menu Icon Submenu Options Main Menu Icon Win1Input 1 2 Win2Input Reset the window display Return to the previous menu Exit Exit from the whole menu Reset NONE NONE Reset the window display Return NONE NONE Return to the previous menu Exit NONE NONE English English Française Française Française Deutsch Deutsch Deutsch Italiano Italiano Italiano Español Español Español 한국어 한국어 한국어 Exit On Power Off Off Return Exit from
PIP (Picture in Picture) Input Information Main screen input source Picture in Picture Additional Input Source DP HDMI DVI Window Swap picture mode DP HDMI DVI Note:"O" means this feature is supported while "X" means it is not supported. The above information is related to input options and the monitor's OSD Menu. For more information on these, refer to the "Basic Setup" and "OSD Menu" sections of the manual.
Troubleshooting 1. The screen is blank. Be sure the power button has been pressed to turn the monitor on. Confirm the brightness and contrast settings are set normally Check if the Indicator Light is flashing, if so, this indicates there is no signal from your video source If your source is a notebook or laptop, be sure that its settings are in mirror mode and the device itself is powered on. 2. The image is out of focus. Ensure the video signal cable is inserted properly on both ends. 3.
Specifications Panel Diagonal Screen Ratio Size 34"(86.36cm) Picture Size (mm) Dot Pitch (mm) 797.22*333.72 0.07725*0.
