User's Manual

HL-TECH Corporation

Federal Communications Commission (FCC) Requirements

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This Transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

Any changes or modifications (including the antennas) made to this device that are not expressly

approved by the manufacturer may void the user’s authority to operate the equipment.

This device is intended only form OEM integrators under the following conditions:

1) The antenna must be installed such that 20cm is maintained between the antenna and users,

and

2) The transmitter module may not be co-located with any other transmitter or antenna.

configurations or co-location with another transmitter), then the FCC authorization is no longer

considered valid and the FCC ID can not be used on the final product. In these circumstances, the

OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and

obtaining a separate FCC authorization.

End Product Labeling

This transmitter module is authorized only for use in devices where the antenna may be installed

such that 20 cm may be maintained between the antenna and users. The final end product must

be labeled in visible area with the following:

“Contains TX FCC ID: SLH-WL-3002B”

End Product Manual Information

The user manual for end users must include the following information in a prominent location

“IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna

used for this transmitter must be installed to provide a separation distance of at least 20cm from all

persons and must not be co-located or operating in conjunction with any other antenna or

transmitter.”

1.This transmitter has been demonstrated co-location compliance requirements with ,this 

transmitter must not be co-located or operating in conjunction with any other antenna or 

transmitter . 

2.This equipment complies with FCC RF radiation exposure limits ser forth for an uncontrolled 

environment. This equipment should be installed and operated with a minimum distance of 20 

centimeters between the radiator and your body . 

