User's Manual

3
1.1.2 Rear and Side Panels
 When both of the cabinet latches, on top of the cabinet are pressed down at the
same time, the cabinet can be opened by pulling forward and down.
 The antenna connectors are for screw-mounting the enclosed antennas.
 The four screw holes are used to mount the base station on the wall.
 The reset switch is used to perform a soft restart of the base station. It is located
in a small hole on the right side of the base station. To press the reset switch,
carefully push a small pointed object, such as an unfolded paper clip, into the hole.
Cabinet latches
Antenna
connectors
Reset switch
(recessed)
Screw holes
for mounting
on wall
Figure 3. Base station rear panel features