User's Manual

PREPARATION FOR INSTALLATION

 About 3 hours are required for the installation.

 Before you begin, coordinate the time of installation with the store owner/manager

to minimize disruption of business.

 Be certain electrical power is available.

 Be certain some type of compatible vehicle detector loop or other vehicle detector

system has already been installed in the drive-thru lane(s).

2.1 Tools Required

 Phillips (cross-point) screwdriver, size #2  wire cutter/stripper

 standard (slotted) screwdriver, ⅛ inch (3.2 mm)  soldering iron

 power drill and drill-bit set  rosin-core solder

fish tape, 100 feet (30 meters)  electrical tape

2.2 Interference Prevention

CAUTION:

Interference may occur if the audio system is not properly installed.

The following types of interference could occur if precautions are not taken during

installation. Read this section carefully before proceeding.

2.2.1 Electrical Interference

Electrical faults in appliances and other electrical equipment can cause interference

such as static, hum, crackling, buzzing and zip sounds in the headset when the

system is active. Interference caused by electrical faults in lighting systems might

not be noticed immediately, since most lighting systems are controlled by a timer or

light-sensing device.

Faulty Wiring or Components:

Faulty components or electrical wiring in menu boards or speaker posts can cause

symptoms identical to those caused by AM interference. Remove power to the menu

board or speaker post at the circuit breaker until the electrical system can be repaired.

Improper Earth Grounds:

Improper earth grounds in the building can cause random buzzing and zip sounds in

the headset when operating in either channel A or B. Placing a surge protector

between the base station AC adapter and the electrical outlet can eliminate the

problem.

In the event of an electrical power outage —

such as from a lightning storm or power generator failure, if you experience problems with your

HME equipment after the electricity comes on again, unplug the equipment and wait 15 seconds,

then plug it back in.