User's Manual

Note: If the base station is a single-lane-only

base station, only Single and Single/A2 options

will be shown.

If the base is configured to Dual/Y or Tandem

modes, there are a number of settings that

become available for both Lanes 1 and 2, that

are displayed as such.

For multiple-lane operations, see Appendix.

Note: Auto Handsfree is also a headset

function. After selecting ✔(on) for the AHF

function on the base, you must also set the

headset(s) to the AHF mode before AHF will

work. Refer to sections 6.3 for single lane,

6.4 for dual/y lanes, and 6.5 for tandem lane

headset AHF settings.

4.2.1 Lane Configuration

To set up the base station for the appropriate drive-thru lane configuration, press the

Configure Lane button on the INSTALLER SETUP display to select Single,

Single/A2, Dual/Y or Tandem. If you change this setting, you must press the Back

button for the base to automatically reset itself and save the setting.

 Single lane configurations support only one lane, speaker post and ceiling speaker.

 Single/A2 configurations operate as a single lane base, but allow store operators to

use A2 as an alternate channel for in-store communication.

 Dual/Y configurations support two lanes, two speaker posts and two ceiling speakers.

(Only available with dual-lane bases)

 Tandem configurations support a single lane with two speaker posts located in line

with each other. (Only available with dual-lane bases)

4.2.2 Auto-Hands-Free

In the Auto-Hands-Free (AHF) mode, transmission and reception are activated

automatically when a customer arrives at the menu board or speaker post.

Communication is transmitted and received at the same time, as in a normal

telephone conversation.

To set up the system to allow AHF operation, press the Auto Handsfree button on the

INSTALLER SETUP display and select ✔(on). To turn AHF off, select −(off). If you

change this setting, you must press the Back button for the base to automatically reset

itself and save the setting.