User's Manual

26
4.2.5 ClearSound
ClearSound reduces environmental noises to improve the intelligibility of incoming
voice transmission from the customer at the outside speaker. Press the ClearSound
button on the INSTALLER SETUP display to access the CLEARSOUND display.
To turn ClearSound noise cancellation on or off, press the Inbound or Outbound
Noise cancel button to highlight ✔(on) or −(off).
Echo cancellation reduces the operator’s voice returning from the outside speaker to
the headset as an echo. To turn echo cancellation on or off, press the Echo cancel
button to highlight ✔(on) or −(off).
Note: Echo cancel will automatically be turned −(off) if half-duplex has been selected.
ANC (Automatic Noise Control) senses when a customer is speaking into the outside
microphone, and reduces the incoming audio level when a customer is not speaking.
To turn ANC on or off, press the ANC button to highlight ✔(on) or −(off).
To save the setting, press the Back button.
4.2.6 Diagnostics
To have the EOS|HD perform diagnostic tests of various functions, press the
Diagnostics button on the INSTALLER SETUP display.
On the DIAGNOSTICS display, you can press the More button to see additional tests
on the ADVANCED DIAGNOSTICS display.
On the left side of either display, press the button for the test to be performed.
Note: Diagnostics are typically
performed with guidance from
HME Technical Support.
Note:
In multiple-lane
configurations, the
CLEARSOUND
display will be divided
by Lanes. Settings
will be similar to those
shown for single lane.