User's Manual

28
4.3.3 Line In/Out Routing
If an external audio source is connected to the base station line input, on the
ADVANCED INSTALLER SETUP display press the Line In/Out routing button.
Press the Line In to: button to select Inbound for the audio from the external source
to be heard in headsets and ceiling speakers, or wherever inbound audio would
normally be heard. Select Outbound for the audio to be heard at the outside speaker.
If any device (e.g. recorder) is connected to the base station line output, press the
Line Out from: button to select whether the audio from the Ceiling speaker,
Outbound audio to the outside speaker, or messages from the Message Center will
be routed to the device connected to the Line Output.
4.3.4 Radio Options
DO NOT CHANGE. Leave RADIO OPTIONS at factory default settings shown below.
Note:
In multiple-lane
configurations, the
LINE IN/OUT
ROUTING display will
be divided by Lines.
Settings will be
similar to those
shown for single lane.