User's Manual

4.3.5 Vehicle Tone

To set up an alert tone to be heard in all headsets when a vehicle arrives in the drive-

thru lane, press the Vehicle tone button on the ADVANCED INSTALLER SETUP

display, and then, on the VEHICLE PRESENT TONE display, press the Vehicle

Present button to select ✔(on). Select −(off) to cancel the alert tone.

To have the alert tone repeated at 3-second intervals, until the Order Taker responds to

the customer, press the Repeat button and select ✔(on). Select −(off) to cancel the

repeating alert tone, to have the tone sounded only once when a vehicle arrives.

4.3.6 Save Installer Settings

To save all the settings you have made, press the Save installer button on the

ADVANCED INSTALLER SETUP display. Your settings will be saved as Installer

Settings. It is highly recommended that you perform this function at the end of the

installation, so the user will have a backup of all installation specific settings.

4.3.7 Language Selection

To select the language to be used, press the Language button on the ADVANCED

INSTALLER SETUP display. On the SELECT LANGUAGE display, press the Select

language button to highlight English, Spanish or French, and then press the Back

button. The base will automatically reset to cause the selected language to take effect.

Note:

In multiple-lane

configurations, the

VEHICLE PRESENT

TONE display will be

divided by Lanes.

Settings will be similar

to those shown for

single lane.